Imaxrc B6-TWINS - Manual (Page 13)

WARNING AND SAFETY NOTES
Program flow chart
FAST CHARGING OF LITHIUM BATTERY
FAST CHARGING OF LITHIUM BATTERY
Charging current will become lower when it progress to the end of
charging. A specific CV process will be reduced to end the charging
process earlier. In fact, the charging current will goes to 1/5 when
the charging process comes to 1/10. Charging capacity will be a
little smaller than normal charging, but charging time will be
shortened accordingly.
STORAGE CONTROL OF LITHIUM BATTERY
You can set up the charging current and voltage of the battery pack.
Press START/ENTTER key to display voltage confirmation. Then
press START/ENTER key again to confirm and begin to charge.
This screen shows the real-time status of 'fast charging'. Press
BATT TYPE/STOP key once to stop the charge process.
This function is for charging/discharging batteries which are not used at once. This program is
designed for charging or discharging of batteries of specific original state. They are classified by
types: 3.75V LiIon, 3.85V LiPo and 3.3V LiFe. The program will begin to discharge if the original
state of the battery exceeds the voltage level of storage.