Konig Electronic Wireless alarm system - Manual (Page 14)

- 14 -
The control panel continuously monitors the system status as well as all the
sensors status. It will monitor occurrences such as triggered sensors, low
battery sensors, malfunction sensors, or phone line failure etc.
In order to check the system status, user can press the “Status” button on the
control panel, voice announcement will be made regarding the system and
sensor status. When the “Status” button is pressed, you will be notified if any of
the following events is occurring:
- System armed or disarmed
- Any triggered sensors
- Any sensors with low battery warning
- Any sensors with failure warning
- Phone line failure
Refer to page 20 for more details regarding system failures.
Arming the System
You should arm the system when you are the last person to leave the house. By
arming the system, the control panel will call the preprogrammed emergency
phone numbers and the siren will sound when break-in occurs.
Caution: Only arm the system when nobody is expected to be inside the premises.
When someone is expected to be within the premises, the system should not be
armed.
To arm the system, follow the procedures below:
1. Press [Arm] button on the control panel when no sensors are triggered.
You can also use the keychain remote to arm the system by pressing arm
button on the remote.
System Status
OPERATION
OR
1. Press [Arm] on the control
panel or keychain remote.
2. Leave the premises
within 45 seconds.
3. After 45 seconds.
System will be armed.
Beep Beep
Exit delay 45 seconds 45 seconds later
ARM LED on. System
Armed