Konig Electronic Wireless alarm system - Manual (Page 28)

- 28 -
ADVANCED PROGRAMMING
To enable alert zone feature, follow the instructions below.
1
2
3
4
Enter Program-
ming mode Enter master
password to
programming mode 3 beeps for valid
password. 1 long beep
for invalid password.
Refer to the
diagram below to
select the
appropriate
setting.
[PROG]
when
finished. Terminate
programming
mode. PROG LED will be
off.
[8]
If alert zone is selected,
that zone LED will be on.
If it is not selected, the
LED will flash. You are
allow to make multiple
changes before terminat-
ing programming mode.
After [8] is entered,
some zone LEDs will
flash or stay on. This
indicates whether alert
zone is selected. Select Alert
Zone.
Select which
zone you
would like to
select as Alert
Zone. Disable
Alert Zone:
[1] to [5]
Enable
Alert Zone:
[6] to [0].
[PROG]
[MPIN]
Zone 1
DISABLE
ALERT ZONE
Button [1]
ENABLE
ALERT ZONE
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons to
Disable Alert Zone
Zone LED : Flash
This row :
Buttons to
Enable Alert Zone
Zone LED : ON
Step Keys Function Description Note