Konig Electronic Wireless alarm system - Manual (Page 33)

- 33 -
ADVANCED PROGRAMMING
Zone 1
SENSOR 1
Button [1]
SENSOR 2
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons for
Sensor 1
Zone LED :
Flash once
This row :
Buttons for
Sensor 2
Zone LED :
Flash twice
Erase Sensors
Proceed to the following to erase a sensor.
1
2
3
[PROG]
[MPIN] Enter
Programming
mode Enter master
password to
programming mode
3 beeps for valid password.
1 long beep for invalid
password.
[9] Select erase
remote
programming After [9] is entered, some
zone LEDs will flash or
stay off. The zone LEDs
represent whether that zone
is occupied by any sensor.
**See Table D below.
Refer to the table
below to select the
remote location. Select the
sensor you
would like to
erase After you have selected the
sensor, you will hear 3 beeps
and verbal confirmation
[Zone X Sensor Y Empty
Memory], where X and Y
are the zone and sensor
numbers you have selected. To erase an
occupied
sensor, press
[1] to [0].
ZONE LED DESCRIPTION
Off Zone is not occupied by any sensor
Flashes once This zone is occupied by sensor 1.
Flashes twice This zone is occupied by sensor 2.
Flashes once, This zone is occupied by sensors 1 and 2.
then twice
** Table D: Zone LED status for erasing sensors.
Step Keys Function Description Note