Konig Electronic Wireless alarm system - Manual (Page 27)

- 27 -
Zone 1
DISABLE
AUTO MUTE
Button [1]
ENABLE
AUTO MUTE
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons to
Disable Auto Mute
Zone LED : Flash
This row :
Buttons to
Enable Auto Mute
Zone LED : ON
ADVANCED PROGRAMMING
Alert Zone (Bypass Zone)
As explained earlier, the control panel can operate in 2 different modes, 1) Alert
Mode, 2) Alarm Mode. In alarm mode, when a sensor is triggered, the control
panel will either give a 30 seconds entry delay, or siren will sound immediately
(with instant alarm). However, there are sensors that you do not want to trigger
the alarm when the system is armed. Such as an outdoor sensor, or any other
sensors that you only want to give you alert notification. Under such circum-
stances, zone(s) can be programed to react only when the control panel is in
alert mode, these zones will be automatically bypassed when the control panel
is in alarm mode. These zones can also be considered as "Bypass zones".
It is recommend to enable alert zone if:
- You do not consider the sensors in that zone an emergency
- Sensors in that zone are located outdoors
- When nobody is home, you do not want to know the status of the sensor(s) in
that zone
Factory Default: This feature was disabled for all zones at the factory.