Konig Electronic Wireless alarm system - Manual (Page 23)

- 23 -
ADVANCED PROGRAMMING
Advanced Programming allows users to customize the control panel to react
differently under different conditions. Features such as:
- When a sensor is triggered, the control panel can beep or alarm
- Beeping can be terminated automatically after a fixed period of time for some sensors
- Some sensors can be programmed to beep only, never alarm
- When a door is open, turn lights on
- Program additional sensors and remotes
Programming Summary
COMMAND DESCRIPTION
[PROG] + [1] Program Phone Numbers
[PROG] + [2] Program Password
[PROG] + [3] Learn Sensors
[PROG] + [4] Learn Keychain
[PROG] + [5] Beep / Alarm Setting
[PROG] + [6] Auto Mute Setting
[PROG] + [7]
[PROG] + [8]
Alert Zone (Bypass) Setting
[PROG] + [9]
Erase Sensors
Erase Keychain or Keypad Transmitters / Control Modules
–
Follow the instructions below to have access to Advanced Programming.
Beep / Alarm
User can customize the audio warning so that when a sensor is triggered, the
control panel may beep or alarm may sound instantly. Depending on whether the
control panel is armed or disarmed, the audio warning is different.
System Disarmed (Alert Mode)
If a zone is set to “Beep”, the control panel will beep when a sensor is triggered,
until the sensor is deactivated. Motion Sensor activation will not cause any
beeping unless the zone for the motion sensor is programmed as a "Bypass
Zone" (see page 30)
If a zone is set to “Alarm”, alarm will sound instantly when a sensor is triggered.
Alarm will stop when the sensor is deactivated, or reaches a 3-minute time out period.