Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 22)

Chapter 3: Getting Started
Product Service 1-800-522-7658 18
18
6.
Press the ▼ button and DI PUMP ENABLE will highlight.
7.
Press ◄ or ► buttons to YES or NO. This allows the pure water valve and pump
to be disabled if pure water will not be used for rinse cycles and prevents
inadvertently programming a cycle to have pure rinses.
8.
Press the ▼ button and LIGHT will be highlighted on the display.
9.
Press ◄ or ► to cause the light inside the tank to be turned on or off while the
door is latched.
10.
Press the ▼ button and FACTORY RESET will be highlighted on the display.
11.
Press the ◄ or ► to select YES to erase all program set points entered by the user
and to restore all set points that were active when the washer was shipped.
12.
Press RUN to save all settings.
Testing Your Washer
Now that you have made the required water and electrical connections to your
washer, a series of diagnostic steps are provided in this section to test the
operation of the washer.
Before turning on the washer, make certain the water is turned on and no packing
material remains inside the washer.
If the washer is interrupted in the middle of the diagnostic steps, wait 4 to 5
seconds before opening the washer door to prevent hot water from splashing out.
The hot water and steam from the washer may cause scalding.
Running the Diagnostics
To ensure your washer is operating properly, perform the diagnostics procedure
detailed below, which will take approximately 10 minutes to complete. Refer to
the figure below to familiarize yourself with the control panel before you begin
the procedure.