Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 56)

Chapter 7: Troubleshooting
Product Service 1-800-522-7658 52
52
PROBLEM CAUSE CORRECTIVE ACTION
Washer will not
drain Clogged drain Clean out drain.
Blockage of air gap Clean the air gap by lifting the cover,
unscrewing the cap, and removing any
accumulated material. See Chapter 5.
Kink in drain hose Check for a kink in the drain hose.
Filter blocked Check filter in washer and clean as needed.
Drain valve or pump
not operating Check operation.
Washer will not
fill Fill valve clogged Clean fill valve.
Water supply turned
off Turn on water.
Defective fill switch Check operation.
Washer overfills Defective fill switch Check operation.
Selection buttons
on control panel
inoperable or
controls
malfunction Microprocessor
memory error Perform "Factory Reset." Open latch on door.
Press
▼ button and simultaneously close door
latch. Release
▼ button and display will show
the set up screen. Press
▼ until FACTORY
RESET is highlighted. Press
► or ◄ until “Yes”
is displayed. Press RUN.
Key pad defective Replace key pad.
Conductivity
reading “High”
(>2000 µs) Water is very
conductive, detergent
has dispensed None.
Sensor defective Replace sensor.
Conductivity
reading “0” Sensor not connected Reconnect sensor wires.
Sensor defective Replace sensor.
Sensor dirty Clean sensor.
Conductivity
reading fluctuates Washing action cause
bubbles None.