Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 50)

Chapter 6: Modifying Your Washer
Product Service 1-800-522-7658 46
46
Installing Small Spindles
Ten small spindles are included with each Spindle Rack. Since the large volume
of water which flows through the standard spindles may be great enough to force
the glassware off the spindle, small spindles should be used when small pieces of
glassware will be washed.
To install small spindles:
1.
Remove the standard spindle by inserting the tool supplied with the Spindle
Rack or a screwdriver into the slot on the top and turning counterclockwise.
2.
Replace the standard spindle with a small spindle.
Installing Optional Inserts into the Spindle Rack
A Multi-Pin Insert is available that can be placed directly on the FlaskScrubber
upper or lower spindle rack. It can hold beakers or wide mouth glassware. The
insert can be positioned either on the left side or right side.
To install an insert:
1.
Remove all glassware, spring retainers and glassware holders.
2.
Lower the insert down over the spindles. If necessary, spindles may be
removed using the tool supplied with the Spindle Rack or a screwdriver in the
slot on the top of the spindles. Be sure to replace any removed spindle with a
plug supplied.