LINK Systems OmniLink - Feed Interface - Manual (Page 14)

OmniLink 5000 Feed Manual December 13, 1999
2.8
Manual Rev 2.3
2.11 Dallas Feed Interface (EXOR Control)
The connection to a Dallas feed with EXOR
control is as follows:
Table 2.10
Dallas (EXOR Control) Connections
Link PN 107865
OmniLink
Feed Port Function / Color Dallas
Comm Port
DB-15 Male
Pin 1
(GND) Ground (WHITE) Pin 5
Pin 2
(RXD) Receive data
from feed
(BLACK) Pin 3
Pin 3
(TXD) Transmit data to
feed (RED) Pin 2
No
Connect Shield (BARE) Pin 1
Pins 10 and
11 Jumpered
Together
Notes:
‚ This feed uses the Reliance IQ2000/IQ5000
feed setting.
‚ Speed and acceleration should be set as
“Unitless” in the Link feed setup screen.
2.12 Emerson Servo Interface
The connection to an Emerson Electronic Feed
is as follows:
Table 2.11
Emerson Connections
Link PN 105721
OmniLink
Feed Port Function / Color Emerson
Serial Port
A
Pin 1
(GND) Ground (WHITE) Pin 5
Pin 2
(RXD) Receive data
from feed
(BLACK) Pin 3
Pin 3
(TXD) Transmit data to
feed (RED) Pin 2
No
Connect Shield (BARE) Pin 1
Notes:
‚ The communication port of the Emerson Feed
Controller must be set to 9600 baud, No axis
identifier, Full duplex, and Auto line feed OFF
(refer to the Emerson manual):