LINK Systems OmniLink - Feed Interface - Manual (Page 6)

OmniLink 5000 Feed Manual December 13, 1999
1.2
Manual Rev 2.3
‚ The roll feed must be supported by the
OmniLink 5000. Supported feeds at the time
this manual was published include:
‚ Coe CPEC/BG1
‚ Coe BG2 **
‚ Coe ServoMaster **
‚ Dallas (EXOR Control) **
‚ Dynamic Feeds **
‚ Reliance/Electro-Craft IQ2000/IQ5000
‚ Emerson Roll Feed
‚ Indramat CLM/SOT/DLC
‚ Indramat CLM/SOT Ver 1.2 **
‚ CWP ServoDial II **
‚ CWP ServoDial 2000
‚ CWP Servomatic **
‚ CWP ServoMax II **
‚ PA Edge/Bullet/Advantage **
‚ RapidAir Feed
‚ Rowe (IQ2000/5000 Based)
‚ Unico Type 1
‚ Unico Type 2
‚ Vamco Feeds (except Pulsar)
‚ Waddington Feed
** = Feed supported only on new
communications card.