Luxul XAP-1040 - Manual (Page 15)

a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450
User Guide
15
POE
Injector
Power
Source
Power
In
Ferrite Noise
Suppresser
Data
Source
Poe
Device
Data/Pwr
Out
Data
In
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.6.6 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE: If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
5 CONFIGURATION
5.1 Login
The XAP-1040 is not equipped with internal DHCP server. If connected to the Luxul
XBR-2300 Enterprise Dual-WAN Router, IP address IP address confi guration will be
automatic. Otherwise, the IP address of the computer for login and confi guration
will need to be manually confi gured. The table below lists the default parameters
of the XAP-1040.
Parameter Default Value
Default IP address 192.168.0.14
Default user name admin
Default password admin
Login to the XAP-1040 Wireless Access Point with the following steps:
a. Be sure the XAP-1040 is properly installed and powered on
b. Open your Web Browser, and enter http://192.168.0.14.
The login window appears as shown below: