1 warnings, 2 site preparation, User guide – Luxul XAP-1040 User Manual
Page 5: Attach only approved power cords to the device
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450
User Guide
5
Enabled for Maximum Compatibility and Performance with Other Luxul Products
1.1 Warnings
Read all installation instructions and site survey reports, and verify correct equip-
ment installation before connecting the XAP-1040 to its power source.
Remove jewelry and watches before installing this equipment.
Verify that the unit is grounded before connecting it to the power source.
Verify that any device connected to this unit is properly wired and grounded.
Connect all power cords to a properly wired and grounded electrical circuit.
Verify that the electrical circuits have appropriate overload protection.
Attach only approved power cords to the device.
Verify that the power connector and socket are accessible at all times during the
operation of the equipment.
Do not work with power circuits in dimly lit spaces.
Do not install this equipment or work with its power circuits during thunder-
storms or other weather conditions that could cause a power surge.
Verify there is adequate ventilation around the device, and that ambient tem-
peratures meet equipment operation specifi cations.
Products outside the approved confi gurations may be in violation of Part 15 of
the FCC Rules.
1.2 Site Preparation
Consult your site survey and network analysis reports to determine specifi c
equipment placement, power drops, and so on.
Assign installation responsibility to the appropriate personnel.
Identify and document where all installed components are located.
Provide a suffi cient number of power drops for your equipment.
Ensure adequate, dust-free ventilation to all installed equipment.
Identify and prepare Ethernet and console port connections.
Verify that cable lengths are within the maximum allowable distances for optimal
and certifi ed signal transmission.