6 regulatory compliance, 1 health and safety recommendations, 2 rf exposure guidelines – Luxul XAP-1040 User Manual

Page 29

Advertising
background image

a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | p: 801-822-5450

User Guide

29

6 REGULATORY COMPLIANCE

The device complies with internationally recognized standards covering human
exposure to electromagnetic fi elds from radio devices. This equipment also
complies with FCC radiation exposure set forth for an uncontrolled environment.
In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not be less than 20 cm (8 inches)
during normal operation.

Unauthorized antennas, modifi cations, or attachments could cause damage and
may violate regulatory approvals. Any changes or modifi cations not expressly
approved by the party responsible for compliance could void the authority to
operate the equipment.

The equipment version marketed in the U.S. is restricted to usage of channels 1-11 only.

6.1 Health and Safety Recommendations

Warnings for the use of Wireless Devices: Please observe all warning notices with
regard to the usage of wireless devices

Potentially Hazardous Atmospheres: You are reminded of the need to observe
restrictions on the use of radio devices in fuel depots, chemical plants etc. and
areas where the air contains chemicals or particles (such as grain, dust, or metal
powders).

Safety in Hospitals: Wireless devices transmit radio frequency energy and may
affect medical electrical equipment. When installed adjacent to other equipment,
it is advised to verify that the adjacent equipment is not adversely affected.

6.2 RF Exposure Guidelines

Safety Information: The device complies with internationally recognized stan-
dards covering human exposure to electromagnetic fi elds from radio devices.

Warning: Exposure to Radio Frequency (RF) Radiation:

The radiated output of this device is below the FCC radio frequency exposure
limits. Nevertheless, the device should be used in such a manner that the potential
for human contact during normal operation is minimized.

The end user must avoid any extended human RF exposure directly in front of
the device, up to a distance of 20cm, when unit is on.

Advertising