Luxul XAP-1040 - Manual (Page 18)

User Guide
18 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.

Bridge Client: Sets the AP into Bridge Client mode allowing it to connect to a
Bridge Root (regular client devices cannot connect to this mode)

Network Name (SSID): Sets the name of the Wireless Network. Default name is
Luxul. It is recommended to change the SSID from the default name. The SSID is
case sensitive and can contain:

2 – 32 alphanumeric characters

Spaces

Special characters (i.e. @#$%&*)
To change the SSID of the wireless network, simply type the desired name, click
Save, and then Reboot for the change to take effect.

Security Mode: Sets the wireless security encryption mode. It is HIGHLY
recommended to change the Security Mode and use the highest security level
supported by the client devices in the network. In most wireless networks, WPA/
WPA2 Personal is an excellent option that will support the largest cross section
of client devices. Security options include:

Open (default - no security)

WEP (128 bit shared key)

WPA Personal

WPA2 Personal

WPA/WPA2 Personal
To change the Security Mode, click the drop down menu and select the desired
mode. The available options for the selected mode will then appear. AFTER all
options are complete, click
Save, and then Reboot for the change to take effect.

Encryption: This fi eld sets the type of encryption to be used by the Security
Mode. The encryption options are dependent upon the Security Mode selected
and this fi eld only shows while in WPA mode. For WEP and WPA2, and WPA/
WPA2 Personal, encryption is automatically set to 128 bits, AES, and TKIP &
AES respectively. For WPA, there are three options: AES, TKIP, and TKIP & AES.
When set to WPA, it is recommended that TKIP & AES be used. To change the
Encryption, click the drop down menu and select the desired encryption type.
Once all options are selected, click
Save and then Reboot for the change to take
effect.

WEP Key: This fi eld only shows while in WEP mode and sets the WEP key to be
used in the network. WEP 128 bit keys require 26 characters. Allowed characters
are numbers 0-9 and letters a-f. There are WEP key generators online that can
automatically create a key. To change the WEP Key, simply enter the 26 character
key then click
Save and then Reboot for the change to take effect.