Luxul XMS-1024 - Manual (Page 11)

luxul.com | 14203 Minuteman Dr | Suite 201 | Draper, UT 84020 | p: 801-822-5450 | f: 801-822-5460
User Guide
11
Attaching the Rubber Feet to the XMS-1024
4.3 Network Connections:
The XMS-1024 supports 10/100/1000 Mbps Ethernet; 10/100 Mbps half/full-
duplex mode and 1000 Mbps full-duplex mode. All RJ-45 ports support Auto MDI/
MDIX and can be used as ordinary ports or as Uplink ports. Any RJ-45 port can be
used to connect the XMS-1024 to an Ethernet enabled device (including servers,
routers, and other switches) without a crossover cable.
The XMS-1024 offers 2 shared SFP optical module expansion ports. Once the
Gigabit SFP optical modules are inserted, these interfaces can support optical fi ber
cables to extend the Gigabit network up to 49 miles—enabling the network to
extend beyond the 300 foot limitation of twisted pair Ethernet.
For the RJ-45 ports, Category-5, super Category-5 or Category-6 unshielded twisted
pair (CAT5/CAT5e/CAT6 UTP) should be used. For best results, it is recommended
that Category-6 shielded twisted pair be used to ensure stable data transmission at
1000 Mbps.
Optical fi ber/cable should be selected based on the wavelength of the SFP optical
module to be used.
Make sure only one Uplink channel exists between switches or between the XMS-
1024 and a router. Otherwise, loops can occur and result in network failure.
4.4 Default IP Address
The XMS-1024 default IP address is 192.168.0.2. This address can be changed.
However, for hassle free installation of other plug and play Luxul devices, it is
recommended that the default IP value be maintained.