Luxul XMS-1024 - Manual (Page 32)

User Guide
32 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Information Base (MIB) of the switch. The XMS-1024 adopts standard MIB-II mod-
ules that support read function from any SNMP-based NMS software. MIB data
may be set to either read-only or read-write mode.
The default SNMP community names of the switch can be user modifi ed.
Traps are messages generated by the XMS-1024 and used for notifi cation of certain
events. Such events may be serious (i.e. switch reboot) or ordinary (i.e. the status
changes of a switch port). The XMS-1024 can generate traps and send them to
the NMS.

SNMP Confi guration:

SNMP: Enables or disables the SNMP management function. SNMP is enabled
by default

SNMP Trap Destination: Sets the destination IP address of the Trap messages
generated by the XMS-1024

SNMP Read Community: Sets the read-only community name. For a device to
read the SNMP information of the XMS-1024, the SNMP management software
must contain the read-only community name

SNMP Write Community: Sets the read/write community name. For a device
to modify the SNMP information on the XMS-1024, the SNMP management
software must contain the read/write community name

SNMP Trap Community: Used by the SNMP management software to identify
the switch sending the Trap message
5.12.2 Change Password

Change Password: Modifi es the password for switch login

Old Password: Enter the old password (Default password is “admin”)

New Password: Enter the new password

Confi rm New Password: Re-enter the new password
NOTE: A password can consist of up to 15 alpha numeric characters.