Luxul XMS-1024 - Manual (Page 12)

User Guide
12 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
CHAPTER:5 CONFIGURATION
This section introduces the confi guration of the XMS-1024 Gigabit Ethernet Smart
Switch functions via the Web-based management interface.

5.1 Login

5.2 Status

5.3 Port Settings

5.4 Mirror

5.5 VLAN

5.6 Trunk

5.7 QoS

5.8 Mac Settings

5.9 802.1X

5.10 RSTP

5.11 IGMP Snooping

5.12 System
5.1 Login
The XMS-1024 is not equipped with internal DHCP server. However, if your switch is
connected to the the XBR-2300 Enterprise Dual-WAN Router, confi guration will be
automatic. Otherwise, the IP address of the computer for login and confi guration
will need to be manually confi gured. The table below lists the default parameters
of the XMS-1024.
Parameter: Default Value
Default IP address: 192.168.0.2
Default user name: admin
Default password: admin
Login to the switch with the following steps:
1. Plug an Ethernet cable into any of the ports of the switch
2. Plug the other end into the Ethernet port of your computer
3. Power on the switch
4. Check to see that the IP address of the computer is within this network segment:
192.168.0.xxx (“xxx” ranges 100~254). For example, 192.168.0.100. For IP address
settings, refer to Appendix 3.
5. Open the Web browser, and enter 192.168.0.2. The switch login window appears,
as shown below.
6. Enter the user name and password (default user name and default password are
both set as “admin”), and then click “OK” to login to the switch confi guration
window.