MOCET IP3062 - Manual (Page 12)

Page 12
MOCET IP3062 Professional IP Phone User Guide
1.3.4. Connect the Handset and Power Adapter to the Phone
After unpacking the box, connect the handset to the curly handset cord and then connect
the other end of the curly handset cord to the port marked HAND with the handset icon
on the bottom of the IP3062. Then connect the included power adapter to the port on the
bottom of the phone marked 5VDC. Please make sure you use the right power adapter. It
will have a label showing 5V and 2A. In some cases, power will be provided from your
network’s Ethernet switches and you will not need to use the included power adapter.
Please check with your network or site administrator for more details on whether your
network supports PoE. And the PoE power specification is compliant IEEE802.3af with
Class 2 level. Please review the following diagram for more assistance.
1.3.5. Connect the Ethernet Cables
Using a general CAT-5 Ethernet cable, follow the installation steps below:
If your Ethernet Switch supports PoE:
- Please connect an Ethernet cable to the Switch port from the LAN port of the
IP3062. Then you will see the phone LEDs and buttons light up momentarily and
the phone will boot.
If your Ethernet Switch doesn’t support PoE:
- Please connect an Ethernet cable to the Switch port from the LAN port
of the
IP3062. Plug in the included power adaptor to the wall power outlet then plug
the barrel plug to the power port on the back of the phone. You should see the
phone LEDs and buttons light up momentarily and the phone will boot.
To eliminate the requirement for multiple Ethernet cables to a user’s location, the user’s
computer can be connected to the network through the second Ethernet port
on the
IP3062.
Notice : The IP3062 takes just under two minutes to start up and become operational.
There are a series of LEDs and buttons that will light up periodically to provide
boot progress information. Please be patient.
Ethernet Switch to
Office LAN or Internet
Power
Adaptor