Rocktron Xpression - Manual (Page 48)

Operating the Xpression ™
Step 8
Step 9 Use the PARAMETER ADJUST control to choose the highest value that the parameter is not
to exceed through MIDI control changes.
Turn the PARAMETER SELECT control one step clockwise to display the Upper Limit
parameter (for PA-A).
ULIM A -2
ULIM A XXX
Note: The Xpression ™ allows you to select an upper and lower value limit which the
parameter cannot exceed. For example, if a parameter has a value range from -
∞
to 0dB, yet you would like the range of the parameter to vary from only -12dB to -
2dB, you may set a lower limit of -12 and an upper limit of -2 via the Upper and
Lower Limit parameters. When a parameter is stored in the Controller Assign
function (Step 7), the maximum parameter value is automatically stored as the
upper limit, while the minimum value is stored as the lower limit.
Step 10
Step 11
LLIM A -
∞
Turn the PARAMETER SELECT control one step clockwise to access the Lower Limit
parameter (for PA-A).
After selecting a value for the upper limit, press the STORE button to save it. "STORED" will
flash briefly on the display.
STORED
45