Record – Rocktron Xpression User Manual
Page 59
To dump a single Xpression preset into a sequencer
Operating the Xpression
Note: When performing data dumps to and from the Xpression, always perform the dump in real time
sequence mode. This will ensure that data loaded back into the Xpression is not sent faster than
the Xpression can receive it.
Also, make sure that the sequencer's MIDI filter is set to accept SYSX information.
Connect a standard MIDI cable from the MIDI OUT of the transmitting Xpression to the
MIDI IN on the receiving sequencer.
Step 1
Step 2
Turn the FUNCTION SELECT controls on the transmitting Xpression until "MIDI DUMP/
LOAD" is displayed.
Step 3
Turn the PARAMETER SELECT control on the transmitting Xpression until "BULK DUMP/
LOAD" is displayed.
MIDI DUMP/LOAD
BULK DUMP/LOAD
TRANSMITTING XPRESSION
TRANSMITTING XPRESSION
Step 4
Start the sequencer recording.
RECORD
56