Rocktron Xpression - Manual (Page 7)

3. Front Panel
1 POWER switch
2 PRESET control
This control scrolls through and instantly recalls the successive presets.
3 TAP (DELAY/RATE) button
This button is used to select a new delay time or modulation rate based on the length of
time occurring between two taps. See Section 7 (page 50): "Tap Delay" for more
information.
4 DISPLAY panel
The DISPLAY panel provides 16 characters consisting of 14 segments each.
5 COMPARE button
The COMPARE button may be used to compare an altered parameter value to its stored
value.
Note: If comparing an altered value to the stored value and the stored value
is currently being viewed, turning a knob or pressing a button that
changes the parameter value displayed will cancel the previous altered
value. This will also occur if a MIDI control change is received while
viewing the stored value(s).
6 PARAMETER ADJUST control
This control is used to adjust the displayed parameter value. When the parameter is
altered from its stored value, the LED above the STORE button will light until either (a)
the new value is stored, (b) a new preset is selected or (c) the parameter is returned to its
original value.
7 STORE button/led
This button is used to store parameter values into the Xpression ™ memory when altered.
See "Storing Changed Preset Parameters" in Chapter 7 (page 40) for more information
on this procedure.
8 PARAMETER SELECT control
When adjusting parameter values, this control will scroll through the available
parameters under the current function heading.
In the "Title Edit" function, this control will scroll through the character locations to be
edited.
4