Rocktron Xpression - Manual (Page 66)

Operating the Xpression
Step 4 Press the STORE button at this time to initiate the All Restore procedure and erase all current
Xpression presets, replacing them with the original factory presets. The Xpression will
display "INITIALIZING" as the Xpression memory is restored.
INITIALIZING
After the All Restore process is completed, the display should read "ERRORS 0". This is the
number of bytes that the Xpression found that did not initialize properly. Any number of
errors other than "0" means that the Xpression may not have initialized properly and the
process should be repeated.
ERRORS 0
The Xpression will remain in this condition until the FUNCTION SELECT
control is turned to exit the Factory Restore function. The preset currently recalled
will be the preset most recently restored into the current location.
The controller assignments for the Xpression can also be reinitialized without
affecting presets and other stored information.
To reinitialize only the controller assignments, enter a code number of "244" at
Step 3 on the preceding page (instead of the "243" shown).
Restoring the Xpression controller assignments:
63