Rocktron MIDI Raider - Manual (Page 37)

34
MIDI, Page 3 of 7 - Control Value Assignment
The third page of the MIDI program, Control Value Assignment, allows
for “on” and “off” controller values to be assigned to instant access
switches and pedals. Control changes can be sent went an instant access
switch is pressed or a controller pedal is moved to aid in selecting a
desired control value.
When controlling specific parameters of other MIDI devices, the “on” and
“off” control values assigned to an instant access switch determine the
high and low parameter values that will be toggled between on the MIDI
receiving device.
When assigning control values to a pedal, the “on” and “off” values
assigned determine the range over which the pedal will provide
continuous control. Typically, the “on” value is the higher value and
determines the control value sent when the pedal is set at the toe position.
The “off” value is generally the lower value and determines the control
value sent when the pedal is set at the heel position. However, these
values can also be reversed so that the toe position of the pedal provides
the lower value and the heel position provides the higher value.
To assign control values to switches and pedals:
() With the 2nD l.e.D. still lit, press the "" switch to access the
next page of the MIDI program, Control Value Assignment. (If
the MIDI raider is not already in the MIDI editing mode, press
“2nD”, then “MIDI” followed by “" two times.)
() Use the "InC" and "DeC" switches directly below the displayed
instant access switch/pedal to select the switch or pedal to which
control values will be assigned. (Only those switches which are
configured as instant access switches will be accessible.)
() Use the "InC" and "DeC" switches directly below the displayed
On value (center of the display) to select the desired On value
to be assigned to the selected instant access switch/pedal. This is
the MIDI control change value sent when the displayed switch is
pressed or turned "on" (l.e.D. on).
() Use the "InC" and "DeC" switches directly below the currently
displayed OFF value (right side of the display) to select the
desired OFF value to be assigned to the selected instant access
switch/pedal. This is the MIDI control change value sent when the
displayed switch is pressed again or turned "off" (l.e.D. off).
Repeat steps  through  for each of the instant access switches/pedals
Note:
When the pedals P1 and P2
are displayed, the Control
Value Assignment page sets the
maximum and minimum values
for the movement of the pedal.
Also:
If Pedal 1 is moved while
displaying the PED1 on/off
values, the display will show
the control values as they are
sent.
