Rocktron MIDI Raider - Manual (Page 41)

38
MIDI, Page 5 of 7 - Program Change Status
The fifth page of the MIDI program, Program Change Status, determines
whether or not the MIDI raider will respond to incoming program
changes, as well as whether to map the incoming program changes to a
preset.
If the MIDI raider is set to respond to incoming program changes, it will
send out information associated with each preset just as if the buttons on
the MIDI raider were pressed. (This feature is operable only when the
MIDI Raider is operating in BANK mode - see SETUP, Page 1).
• When set to OFF, the MIDI raider will not respond to
incoming program changes.
• When set to ON, he MIDI raider responds to incoming
program changes without mapping.
• When set to MAP, the MIDI raider responds to incoming
program changes and maps any assigned patch changes (see
MIDI, page 6).
To set the program change status:
() With the 2nD l.e.D. still lit, press the "" switch to access the
next page of the MIDI program, Program Change Status. (If
the MIDI raider is not already in the MIDI editing mode, press
“2nD”, then “MIDI”, followed by “" four times.)
() Use the "InC" and "DeC" switches directly below the displayed
Program Change status to select the desired status.