Rocktron Intellifex LTD - Manual (Page 14)

11
6. Principle of Operation
Caution: Digital Output overload
As the input signal enters at the unit’s input (A), the unaltered direct signal is
fed to the Direct Pre/Post Hush ® Selector (B). Here you may choose for the
direct signal to remain unaltered (Pre) or feed it through the digital Hush ®
section (E) of the Intellifex LTD (Post). Before being fed to the Hush ® section,
the signal must first be converted from an analog signal to digital via the
converter (D). When the direct signal is fed to the Hush ® section, it will remain
digital until it is summed together with the output of the Effects Level control
(G).
It is important to remember that it is possible to overload the Digital to Analog
Converter (H) if the effects levels and direct signal level are set too high when
using the Hush ® section with the direct signal. If this occurs, reduce these
levels until the front panel CLIP L.E.D. does not light.
Also note that when passing the direct signal through the digital HUSH ® (Post),
a stereo signal will be converted to mono.
6. Principle of Operation
A. MIXER SECTION
The first function accessible when turning the FUNCTION SELECT control in any
preset is the Mixer function. This digital mixer allows you to control the signal levels
pertaining to each preset’s configuration and stores these levels for each preset.