Rocktron Intellifex LTD - Manual (Page 46)

43
Turn the PARAMETER ADJUST control to scroll through the available parameters for the
current configuration.
PARA1 XXX
Step 5 Turning the PARAMETER SELECT control one step clockwise will display the effect
parameter that is currently mapped to the NUMB1 control number.
PARA1 EFFECTS LVL
Step 6
After selecting the parameter to be assigned to the NUMB1 controller, press the STORE
button to save it. "STORED" will flash briefly on the display. Step 7
STORED
The Intellifex allows for the range of any given parameter to be limited when using a MIDI
controller to determine the current parameter value. For example, if a given parameter has
a range from -
∞
to +6dB yet it is desirable for the full range of the controller to vary from
only -10dB to +2.5dB, a lower limit of -10 and an upper limit of +2.5 may be set via the
"Upper Limit" and "Lower Limit" parameters. When storing a parameter, the maximum
value is stored as the upper limit and the minimum value is stored as the lower limit auto-
matically.
NOTE
Turn the PARAMETER SELECT control to display the next parameter - "Controller Upper
Limit". Step 8
ULIM C1 XXX
Use the PARAMETER ADJUST control to select the highest parameter value that the
controller is not to exceed. Step 9
ULIM C1 +2.5
Step 10 After selecting the value for the upper limit, press the STORE button to save it. "STORED"
will again flash briefly on the display.
STORED