Rocktron Intellifex LTD - Manual (Page 5)

2
2. Quick Setup
2. Quick Setup
STEP 3 Now press the STORE button a second time to store the modified values
into the selected preset location. The Intellifex LTD will display "STORED"
briefly before displaying the new preset number/title.
RECALLING A STORED INTELLIFEX LTD PRESET
STEP 1 To recall a stored Intellifex LTD preset, first turn the PRESET control to
the desired preset number you wish to recall. The display will alternate
between the preset number/title selected and:
PRESS RECALL FOR
STEP2 To call up the preset you have selected, press the RECALL button. The
display will now show only the new preset number/title.
14 PRESET TITLE
CHANGING PRESET PARAMETERS
STEP 1 The parameter menu for each effect can be called up via the FUNCTION
SELECT control. Turn this control to the effect to be changed.
**** REVERB ****
STEP 2 Turn the PARAMETER SELECT control to select which parameter select
the parameter to be modified.
REV DECAY 59
STEP 3 Use the PARAMETER ADJUST control to modify the parameter value.
The LED above the STORE button lights to indicate that a parameter
value has been modified from the stored preset.
REV DECAY 32
STEP 4 The COMPARE button may be used to compare the stored value to the
new one.
REV DECAY 59
STORING MODIFIED PARAMETER VALUES
STEP 1 To store modified parameter values, press the STORE button while
viewing a parameter or effect title to begin the store procedure. The
Intellifex LTD will alternate displaying the current preset number/title and:
STORE TO PRESET
STEP 2 Turn the PRESET control to select the desired preset number to store the
new parameter values into (if the new values are to be stored into the
current preset location, this step is not necessary). User presets may be
stored in preset locations 1-80. Presets 81-160 are factory presets and
cannot be copied over. The Intellifex LTD will now alternate displaying the
new preset number/title and:
STORE TO PRESET
STORED
STEP 4 After the modified parameters have been stored into a new preset
location, the Intellifex LTD will display "COPY TITLE TOO?". This occurs
only when a new preset location is selected to store the modified
parameters into, and allows for the title from the original preset to be
copied to the new preset location as well. To copy the title, press the
STORE button a third time. The display will again flash "STORED".
NOTE 1 If it is not desired to copy the title from the original preset, turn either the
PRESET or FUNCTION SELECT control to exit the store procedure.
NOTE 2 If a modified preset is edited without completing the store procedure (i.e.
"STORED" displayed at least one time), all edited parameter values will
be lost and the preset will revert to its original condition the next time it is
recalled. When saving altered parameters, always make sure the Intellifex
LTD flashes "STORED" at least once before exiting the preset to ensure
that the desired modifications were stored into memory.