Reloading the user memory from a sequencer – Rocktron Intellifex LTD User Manual
Page 55
52
Reloading the user memory from a sequencer:
Connect the MIDI OUT of the sequencer to the MIDI IN on the Intellifex LTD with a
standard MIDI cable.
Step 1
Turn the FUNCTION SELECT control on the Intellifex LTD fully clockwise to the "MIDI
DUMP/LOAD" position.
Step 2
MIDI DUMP LOAD
Turn the PARAMETER SELECT control to the "LOAD USER DATA" position. The
Intellifex LTD is now ready to receive the user data from the sequencer.
Step 3
LOAD USER DATA
Play back the user data previously recorded on the sequencer. The Intellifex LTD will
display the data strings as it is storing them. The data string and "LOADED" will appear on
the display. After all the user data has been loaded the Intellifex LTD will display "USER
DATA LOADED". The entire procedure will take approximately 3 minutes to complete.
Step 4
USER DATA LOADED
Do not play back data from the sequencer faster than it was recorded, as errors may occur.
Errors may also occur if any knob is turned or any button is pressed before the message
“USER DATA LOADED”appears.