Rocktron Intellifex XL - Manual (Page 45)

42
Turn the PARAMETER ADJUST control to scroll through the available parameters for the
current configuration.
PARA1 XXX
Step 5 Turning the PARAMETER SELECT control one step clockwise will display the effect
parameter that is currently mapped to the NUMB1 control number.
PARA1 EFFECTS LVL
Step 6
After selecting the parameter to be assigned to the NUMB1 controller, press the STORE
button to save it. "STORED" will flash briefly on the display. Step 7
STORED
The Intellifex allows for the range of any given parameter to be limited when using a
MIDI controller to determine the current parameter value. For example, if a given
parameter has a range from -
∞
to +6dB yet it is desirable for the full range of the
controller to vary from only -10dB to +2.5dB, a lower limit of -10 and an upper limit
of +2.5 may be set via the "Upper Limit" and "Lower Limit" parameters. When storing
a parameter, the maximum value is stored as the upper limit and the minimum value is
stored as the lower limit automatically.
NOTE
Turn the PARAMETER SELECT control to display the next parameter - "Controller Upper
Limit". Step 8
ULIM C1 XXX
Use the PARAMETER ADJUST control to select the highest parameter value that the
controller is not to exceed. Step 9
ULIM C1 +2.5
Step 10 After selecting the value for the upper limit, press the STORE button to save it. "STORED"
will again flash briefly on the display.
STORED