Rocktron Intellifex XL - Manual (Page 8)

5
1) R(MONO) INPUT jack:
This standard 1/4" mono jack provides input to the right channel of the Intellifex XL. When
using only one input (mono), this jack should be used.
2) L INPUT jack:
This standard 1/4" mono jack provides input to the left channel of the Intellifex XL. When
using only one input, this jack should not be used.
3) R OUTPUT jack:
This standard 1/4" mono jack provides an output for the right channel of the Intellifex XL.
When using the unit in a mono application, either output jack may be used.
4) L OUTPUT jack:
This standard 1/4" mono jack provides output for the left channel of the Intellifex XL. When
using the unit in a mono application, either output jack may be used.
5) PHANTOM POWER jack:
This jack offers the ability to power the Rocktron MIDI Mate ™ Foot Controller from a seven
pin MIDI cable which connects from the MIDI Mate to the MIDI IN jack on the rear panel
of the Intellifex XL, eliminating the need to find an AC outlet near where the footpedal
would be placed during a performance - or the need to run an extension cord out to the
MIDI Mate. Instead of inserting the adaptor into the MIDI Mate
™ POWER jack, plug it into
the PHANTOM POWER jack on the Intellifex XL. This will power the MIDI Mate ™
through pins 6 and 7 of the MIDI cable connecting the two units. A 7-pin MIDI cable must
be used and is available through your Rocktron dealer.
6) MIDI IN jack:
This 7-pin DIN connector receives MIDI information from the device which is transmitting
the MIDI commands for the Intellifex XL to execute.
7) MIDI OUT/THRU jack:
This standard 5-pin DIN connector passes on the MIDI information that is received at the
MIDI IN jack to other MlDI-compatible devices via a MIDI cable. It also outputs MIDI data
when performing a memory dump.
Note: Inherently in MIDI there is a limit to the number of devices which can be chained
together (series connected). With more than three devices, a slight distortion of the MIDI
signal can occur (due to signal degradation) which can cause an error in MIDI signal
transmission. Should this problem arise, a MIDI box can be used which connects directly to
the MIDI device which transmits MIDI information and has multiple connectors for the
multiple devices receiving MIDI. MIDI cables should not exceed 50 feet (15 meters) in
length.
8) POWER jack:
This jack accepts power from the 9VAC/1500mA adaptor supplied with the unit.
4. Rear Panel
G
Note
When using a mono input and a
mono output, the left and right
effect signals will be summed at
the single output.