ROHO SelectAir MA mattress - Manual (Page 11)

9
Section 5 Installation
Installation - Mattress Replacements
Mattress
Note: Make sure that the mattress hose fitting is at the foot end of the
bed frame.
A. When using the Mattress Cover with Mattress Replacement:
While the mattress is inflating, it may be helpful to partially unzip the cover and
guide the mattress into the correct formation.
1. Always remove the existing mattress from the bed.
2. Before placing mattress inside mattress cover, ensure that all four side bolster
straps (two per side) are securing side bolsters to mattress sections and Velcro ®
fasteners are mated.
3. Insert the mattress and mattress pad inside the mattress cover and zip the cover
shut. Place on the bed frame. Be sure the hole in the mattress cover is in the
correct position to fit around the hose fitting outlet on the mattress.
4. Strap the cover to the bed frame using the four straps located on each side of the
mattress cover.
B. When using the Mattress Cover and the Mattress Sheet with Mattress
Replacement:
1. Always remove the existing mattress from the bed.
2. Before placing mattress inside mattress cover, ensure that all four side bolster
straps (two per side) are securing side bolsters to mattress sections and Velcro ®
fasteners are mated.
3. Insert the mattress and mattress pad inside the mattress cover and zip the cover
shut. Place on the bed frame. Be sure the hole in the mattress cover is in the
correct position to fit around the hose fitting outlet on the mattress.
4. Strap the cover to the bed frame using the four straps located on each side of the
mattress cover.
5. Fit the mattress sheet over the covered mattress and attach the straps to the bed
frame.
Installation - Overlay Models
Mattress Overlay
Note: Make sure that the mattress hose fitting is at the foot end of the
bed frame.
A. Mattress Overlay Instructions
1. Place the mattress overlay on top of the existing mattress.
2. Insert hose into the foot section of the mattress overlay.
3. Insert the ROHO HIGH PROFILE cushion into the cushion cover.(HybridSelect TM only.)