Summit Audio ECS-410 Everest Channel Strip User Manual
Page 14
14
Summit Audio, Inc.
Connections
The TRS jack wiring on the Dynamics insert is as follows: the Tip is
the output of the Gain Cell, and the Ring connects to the input of
the Sidechain Processor.
Stereo Link
Link mode allows the Dynamics section of two ECS-410 Everest
units to be linked to process stereo signals. When two units
are linked in this way, the leveling action will be the same on
both units. When stereo linked, the channel providing the most
compression will always control the other unit.
To “Stereo Link” two units:
Connect a standard 1/4” mono audio cable between the
1.
“Stereo Link” jack of two ECS-410 units.
Set the controls on both units the same.
2.
Set the BYPASS switch on the front panel to LINK.
3.
A.C. Receptacle
The ECS-410 Everest is factory wired for either 100, 115 or 230
Volts AC. Before connecting AC power make sure the unit is wired
for the correct voltage used in your country.