Summit Audio ECS-410 Everest Channel Strip - Manual (Page 22)

22 Summit Audio, Inc.
Dc1- Dual Mode Dynamics Control
Bypass/Link Switch
In Bypass mode the Dc1 is switched completely out of the signal
path whether patched via TouchPatch or the direct I/O.
Link mode allows the Dynamics section of two ECS-410 Everest
units to be linked to process stereo signals. When two units are
linked in this way, the leveling action will be the same on both
units. When linked, the channel providing the most compression
will always control the other unit.
To “Stereo Link” two units:
Connect a standard 1/4” mono audio cable between the 4.
“Stereo Link” jack of two ECS-410 units.
Set the controls on both units the same.
5.
Set the BYPASS switch on the front panel to LINK. 6.
TouchPatch Indicator
This LED lights to indicate that the Dynamics section is routed to
the internal DriveBus.
Outputs of any section are always active, even if routed via Touch-
Patch. If not routed via TouchPatch inputs as well as outputs are
active.