Taser X26 - Manual (Page 12)

12 TASER® CDPM Operating Manual • MMU0014 Rev: B
10. Place the safety switch in the down (SAFE) position.
Note: It is advisable to confirm proper numeric entry of the 5-digit activation code at this time. To do
so, cycle the safety switch back to the up (ARMED) position and cycle through the entered activation
code via the trigger switch to verify code entry. The X26 device will not spark or deploy if either the
green CCDPM or red DCDPM is inserted. Do not attempt to check the activation code when a CDPM
or DPM/XDPM™ is inserted in the device, the trigger activation will deploy the X26 device.
11. Remove the green CCDPM and insert the CDPM with the lanyard/wrist strap attached.
Note: If the lanyard/wrist strap is disconnected for an extended period of time from the CDPM
(approximately 24 hours) while the CDPM is inserted in an X26 device, a “brown out” condition may
occur. A “brown out” condition will reset the internal clock of the X26 device to “0” thereby preventing
accurate accountability of device use. The “brown out” condition will be rectified the next time the
device information is downloaded via the dataport software but the informational time stamps will
not be accurate for those uses which occurred after the “brown out” condition occurred.
TASER
recommends that the lanyard/wrist strap stay attached to the CDPM at all times when the
CDPM is both in and out of the X26 device.