Taser X26 User Manual
Page 6
6
TASER® CDPM Operating Manual •
MMU0014 Rev: B
PHYSICAL DESCRIPTION
The CDPM has a safety lock on its base. The lanyard/wrist strap is attached to a safety key. Use the
safety key to attach the 2-piece lanyard/wrist strap to the CDPM safety lock.
CONFIGURING A TASER X26 DEVICE FOR THE CDPM
Note: Do not perform this procedure with an X26C (citizen) device. If you insert a CCDPM into an
X26C device, the CID will display a “P” and then the error code “EO”. Insert a standard DPM programmed
with version 22 or higher into the device in order to recover it.
1. Verify that the TASER cartridge is removed. Failure to remove the TASER
cartridge prior to configuration may cause serious injury.
2. Verify that the safety switch is in the down (SAFE) position (Figure 4).
Figure 4