Taser X26 - Manual (Page 16)

16 TASER® CDPM Operating Manual • MMU0014 Rev: B
DE-CONFIGURING A TASER X26 DEVICE
1. Verify that the TASER cartridge is removed. Failure to remove the TASER
cartridge prior to de-configuration could cause serious injury.
2. Verify that the safety switch is in the down (SAFE) position.
3. Remove the CDPM from the X26 device.
4. Insert the red DCDPM into the X26 device.
5. A “P” is displayed on the X26 device CID for about 6 seconds, indicating
that the configuration code is being de-programmed from the device.
When deprogramming is complete, a two-digit DCDPM revision level is displayed.
6. Place the safety switch in the up (ARMED) position. The CID will display battery capacity
followed by display of “Cd” indicating that de-configuration has completed (see Figure 18).
7. Once “Cd” has been displayed, place the safety switch in the down (SAFE) position.
8. Remove the red DCDPM from the X26 device.
Figure 18