Xblue Networks X16 - Manual (Page 14)

X16 Installation Guide
- 14 - Issue 2
Sy
ste
m
Co
nfi
gu
ra
tio
n
Step 2 – CO Line Connections
The X16 system supports a single CO Line per port, or two CO lines in
ports labeled
1/2 and 3/4 .
Note:
The port labeled “Line 1” is a direct access auxiliary port for line 1 allowing an
analog device direct access.
Telephone lines are usually found on the center pair (White/Blue) of the
telephone jack (RJ11). Sometimes a second line will be connected to the
outer pair (White/Orange). The system is design to accommodate both types
of installations. When using only the center pair, connect 1 telephone line to
each of the 4 ports in the system. When using both the center and outer
pairs, use only ports labeled 1/2 and 3/4 to connect all 4 lines. The existing
cabling will determine how the telephone lines will be connected to the
system.
Note: The port labeled “Line 1” gives you access to the telephone company line
(white/blue) plugged into the Central Office Port labeled 1/2. This is useful during a Power
Failure or anytime you want to access to line 1 from an Analog telephone.
Line Port Number
AUX CO Line1
CO Line 1 1 / 2
CO Line 2 2
CO Line 3 3 / 4
CO Line 4 4
CO Line 5 5
CO Line 6 6
4 3/4 2 1/2 AUX
CO Lines
6 5