Xblue Networks X16 - Manual (Page 29)

Issue 2 - 29 -
Fe
at
ur
e
De
sc
rip
tio
n
2) If an ancillary device (single line before the system) is on a CO Line,
and the system does not detect that line as being busy, the system
will forward the call, and dial over the call.
3) This feature is considered disabled if no number is entered in the
“FWD Phone Number” field.
4) At default the “External” transfer will release after 3 minutes. Use
the following codes to extend the length of the call
a.  – Extends the call by 1 Minute
b.  – Extends the call by 2 Minutes
c.  – Extends the call by 3 Minutes
d.  – Extends the call by 4 Minutes
e.  – Extends the call by 5 Minutes
f.  – Extends the call by 6 Minutes
g.  – Extends the call by 7 Minutes
h.  – Extends the call by 8 Minutes
i.  – Extends the call by 9 Minutes
j.  – Extends the call by 20 Minutes
k.  – Extends the call by 30 Minutes
l.  – Disconnects both lines immediately
Note:
This type of forwarding may result in a per call usage and toll charge for each forwarded
call. Any and all toll charges are the sole responsibility of the user of the installed
equipment; XBLUE offers no warranty or will assume any responsibility for any toll charges.
Hands-Free Calling
Calls between extensions are answered hands-free. This allows extension users
to answer and converse without pressing the speaker button or lifting the
handset. If “Auto Mute” is enabled the called party will be able to hear the calling
party, but they will not be able to converse without pressing the mute button or
going off hook on the handset. There will be one, 1 second tone when an
extension calls another extension. At default, Auto Mute is disabled (off).
Handset/Headset Volume Control
The volume of the handset and headset can be adjusted to compensate for
hearing levels. Press the volume + to increase or the volume- to decrease the
volume of the active status of the endpoint. For example, while speaking on the
handset, the volume keys will adjust the handset volume.