Xblue Networks X16 - Manual (Page 30)

X16 Installation Guide
- 30 - Issue 2
Fe
atu
re
De
sc
rip
tio
n
Headset Activation
Each digital telephone endpoint comes with a 1/8 inch (2.55 mm) standard
“cellular” style telephone headset jack, which can be activated by dialing the
feature code
Feature +  . This feature code can be programmed on a button, so
that headset can be enabled and disabled as needed. In addition, a headset
must be plugged in to enable or disable headset mode.
Note:
The voice quality and performance of headsets may vary .
Hold
Extension users may place Telephone Company central office line calls on hold
allowing them to be picked up at other extensions.
Hot Dial Pad
Hot dial pad allows extension users to dial numbers without lifting the handset or
pressing the speaker button.
Intercom Calling
Each extension is assigned a unique three digit code (number) ranging from 301
to 399. The number used at the time of registration and becomes that
extension‟s intercom number. Dial the three digit code to intercom another
extension. DSS/BLF buttons allows for one touch intercom calling.
Intercom Paging
Intercom paging is similar to intercom calling, but when the call is connected, the
called party‟s mute button is active. This allows the called party to have private
conversations without being overheard.
Line Status Detection (Line in Use)
From Idle to Busy – The system will detect if another device is using one of the
CO Lines and will automatically identify the line as busy.
From Busy to Idle – The system will detect when the line is no longer busy, and
automatically identify the line as idle.
Not Connected – If a CO line is not connected to the system, it will be
automatically disabled, and no one will be able to connect to the line. A beep
tone is heard if a disabled CO Line is pressed.