Transport and storage, Transport, Storage – Pilz Cable PMCprimoDrive>Mod-Profibus:L=0,45m User Manual
Page 21
Operating Manual: PMCtendo AC
5-1
Transport and Storage
Transport
The servo motors must be transported in such a way that no damage can occur.
INFORMATION
Be sure to avoid any impact, jerky movements or heavy vibration during transportation.
Storage
If a servo motor is not to be put into service immediately upon delivery, make absolutely
sure that it is stored correctly.
The servo motors should only be stored in an enclosed room that is dry, dust free and
ventilated. Please refer to the information provided under “Technical Details”.
Do not remove anti-corrosion coatings on the shaft ends, flange surfaces, etc. While in
storage, these should be inspected at defined intervals and any damage made good.
The storage site should not be liable to vibration. When servo motors are kept in storage
we recommend that the rotor is rotated at defined intervals to prevent corrosion on the
bearings.
If the servo motor has been in storage for more than 3 months, rotate the servo motor in
both directions at low speed (< 100 min
-1
) to ensure that the lubricant on the bearings is
distributed equally.