Mercedes-Benz 2013 C Class Sedan - Manual (Page 142)

Useful information
i This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences are
possible. Please note that your vehicle may
not be equipped with all features
described. This also applies to safety-
related systems and functions.
i Read the information on qualified
specialist workshops: ( Y page 25).
Notes on breaking-in a new vehicle
Important safety notes
New and replaced brake pads and discs only
reach their optimum braking effect after
several hundred kilometers of driving.
Compensate for this by applying greater force
to the brake pedal.
The first 1,000miles (1,500 km)
The more you look after the engine when it is
new, the more satisfied you will be with its
performance in the future.
R
You should therefore drive at varying
vehicle and engine speeds for the first
1,000 miles (1,500 km).
R
Ideally, for the first 1,000 miles (1,500 km),
drive in program
E (for AMG vehicles drive
program C).
R
Avoid heavy loads, e.g. driving at full
throttle, during this period.
R
Change gear in good time, before the
tachometer needle is Ô of the way to the
red area of the tachometer.
R
Do not manually shift to a lower gear to
brake the vehicle.
R
If possible, do not depress the accelerator
pedal past the point of resistance
(kickdown).
R
Only select shift ranges 3, 2 or 1 when
driving slowly, e.g. in mountainous terrain.
After 1,000 miles (1,500 km), you can
increase the engine speed gradually and
accelerate the vehicle to full speed.
Additional breaking-in notes for AMG
vehicles:
R
Do not drive faster than 85 mph
(140 km/h) for the first 1000 miles
(1500 km).
R
Only allow the engine to reach a maximum
engine speed of 4,500 rpm briefly.
R
Change gear in good time.
i You should also observe these notes on
breaking in if the engine or parts of the drive
train on your vehicle have been replaced.
i Always observe the respective speed
limits.
AMG vehicles with self-locking rear
axle differential
Your vehicle is equipped with a self-locking
differential on the rear axle. Change the oil
after a breaking-in period of 2,000 miles
(3,000 km) to improve protection of the rear
axle differential. This oil change prolongs the
service life of the differential. Have the oil
change carried out at a qualified specialist
workshop.
Driving
Important safety notes
G
WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle
is jeopardized. There is a risk of an accident.
140
Driving
Driving and parking