Driving and parking, Driving systems – Mercedes-Benz 2013 C Class Sedan User Manual

Page 193

Advertising
background image

G

WARNING

Active Blind Spot Assist does not react to:

R

vehicles overtaken too closely on the side,
placing them in the blind spot area

R

vehicles being overtaken at a speed
difference of more than 7.5 mph
( 12 km/h)

R

vehicles which approach with a large speed
differential and overtake your vehicle

As a result, Active Blind Spot Assist may
neither give warnings nor intervene in such
situations. There is a risk of an accident.
Always observe the traffic conditions
carefully, and maintain a safe lateral distance.

i

USA only:

This device has been approved by the FCC
as a "Vehicular Radar System". The radar
sensor is intended for use in an automotive
radar system only. Removing, tampering
with, or altering the device will void any
warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.

i

Canada only: This device complies with

RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Removal, tampering, or altering of the
device will void any warranties, and is not
permitted. Do not tamper with, alter, or use
in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.

Monitoring range of the sensors

G

WARNING

Active Blind Spot Assist does not detect all
traffic situations and road users. There is a
risk of an accident.
Always make sure that there is sufficient
distance on the side for other traffic or
obstacles.

In particular, the detection of obstacles can
be impaired if:

R

dirt on the sensors or anything else
covering the sensors

R

poor visibility, e.g. due to rain, snow or
spray

Vehicles in the monitoring range are then not
indicated.
Active Blind Spot Assist may not detect
narrow vehicles, such as motorcycles or
bicycles, or may only detect them too late.

Active Blind Spot Assist monitors the area up
to 10 ft (3 m) behind your vehicle and directly
next to your vehicle, as shown in the diagram.
For this purpose, Active Blind Spot Assist
uses radar sensors in the rear bumper.
If the lanes are narrow, vehicles driving in the
lane beyond the lane next to your vehicle may
be indicated, especially if the vehicles are not
driving in the middle of their lane. This may

Driving systems

191

Driving and parking

Z

Advertising