If necessary, add engine oil, Maintenance and care, Engine compartment – Mercedes-Benz 2013 C Class Sedan User Manual

Page 287

Advertising
background image

oil consumption may be higher than this when
the vehicle is new or if you frequently drive at
high engine speeds.
Depending on the engine, the oil dipstick may
be in a different location.
When checking the oil level:

R

park the vehicle on a level surface.

R

the engine should be switched off for
approximately five minutes if the engine is
at normal operating temperature.

R

if the engine is not at normal operating
temperature, e.g. if the engine was only
started briefly: wait about 30 minutes
before carrying out the measurement.

Checking the oil level using the oil

dipstick

X

Park the vehicle on a level surface.
To check the oil level with the engine at
operating temperature, switch the engine
off and wait for approximately five minutes.

X

Pull oil dipstick : out of the dipstick guide
tube.

X

Wipe off oil dipstick :.

X

Slowly slide oil dipstick : into the guide
tube to the stop, and take it out again.
If the level is between MIN mark = and
MAX mark ;, the oil level is correct.

X

If the oil level has dropped to MIN mark
= or below, add 1.1 US qt (1.0 liter) of
engine oil.

Adding engine oil

G

WARNING

If engine oil comes into contact with hot
components in the engine compartment, it
may ignite. There is a risk of fire and injury.
Make sure that engine oil is not spilled next
to the filler neck. Let the engine cool down
and thoroughly clean the engine oil off the
components before starting the engine.

H

Environmental note

When adding oil, take care not to spill any. If
oil enters the soil or waterways, it is harmful
to the environment.

!

Only use engine oils and oil filters that

have been approved for vehicles with a
service system. You can obtain a list of the
engine oils and oil filters tested and
approved in accordance with the
Mercedes-Benz Specifications for Service
Products at any Mercedes-Benz Service
center.
Damage to the engine or exhaust system is
caused by the following:

R

using engine oils and oil filters that have
not been specifically approved for the
service system

R

replacing engine oil and oil filters after
the interval for replacement specified by
the service system has been exceeded

R

using engine oil additives.

!

Do not add too much oil. If the oil level is

above the "max" mark on the dipstick, too
much oil has been added. This can lead to
damage to the engine or the catalytic
converter. Have excess oil siphoned off.

Engine compartment

285

Maintenance and care

Z

Advertising