Mercedes-Benz 2011 E Class Sedan - Manual (Page 331)

X Make sure pressure release screw F on
pressure gauge G is fully closed.
X Screw filler hose D onto valve E.
X Insert connector A into the cigarette
lighter socket (
Y page 292) or into a 12 V
socket in your vehicle ( Y page 292).
X Turn the key to position 1( Y page 149) in
the ignition lock.
X Press on/off switch ? on the electric air
pump to
I.
The electric air pump is switched on. The
tire is inflated.
i First, TIREFIT is pumped into the tire. The
pressure can briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the electric pump
during this phase.
X Let the electric pump run for five minutes.
The tire should then have attained a
pressure of at least 180 kPa (1.8 bar/
26 psi).
G Warning
The air hose can become hot during inflation.
Please exercise appropriate caution.
! Do not operate the electric air pump for
longer than eight minutes at a time without
a break. It may otherwise overheat.
The air pump can be operated again once
it has cooled down.
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has been achieved, see
(
Y page 330).
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved, see
(
Y page 330).
TIREFIT kit version 2
X Pull connector ? with the cable and hose
A out of the housing.
X Screw hose A onto flange B of TIREFIT
sealant filler bottle :.
X Place TIREFIT sealant filler bottle : head
downwards into recess ; of the electric
air pump.
X Remove the cap from valve C on the faulty
tire.
X Screw filler hose D onto valve C.
X Insert plug ? into the cigarette lighter
socket (
Y page 292) or into a 12 V socket
in your vehicle ( Y page 292).
X Turn the key to position 1( Y page 149) in
the ignition lock.
X Press on/off switch = on the electric air
pump to
I.
The electric air pump is switched on. The
tire is inflated.
Flat tire
329
Roadside Assistance
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi
Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 329
Z