Subaru 2003 Impreza - Manual (Page 187)

IMPREZA(NA) A1850BE-A (ENGLISH)
Audio
5-20
B Manual tuning (TUNE)
"" : Tuning to a higher frequency
AA : Tuning to a lower frequency
""❚ : Seeking the next higher station
❚AA : Seeking the next lower station
n Manual tuning
Turn the tuning knob (4) clockwise and release it im-
mediately to increase the tuning frequency and turn
the tuning knob counterclockwise and release it im-
mediately to decrease the tuning frequency.
Each time the knob is turned, the frequency
changes 10 kHz in the AM waveband and 0.2 MHz
in the FM waveband.
n Seek tuning
Turn the tuning knob (4) and hold it for more than a
half second. Seek tuning will operate and stop auto-
matically on the next station.
Continue this operation until you find the desired
station.
B Automatic tuning (SCAN)
Press the “SCAN” button (3) to change the radio to
the SCAN mode. In this mode, the radio scans
through the radio band until a station is found. The
radio will stop at the station for five seconds while
displaying the frequency, after which scanning will
continue until the entire band has been scanned
from the low end to the high end.
Press the “SCAN” button again to cancel the SCAN
mode and to stop on any displayed frequency.
When the “SCAN” button is pressed for automatic
tuning, stations are scanned in the direction of low
frequencies to high frequencies only.
Automatic tuning may not function properly if the sta-
tion reception is weakened by distance from the sta-
tion or proximity to tall buildings and hills.
B Selecting preset stations
Presetting a station with a preset button (5) allows
you to select that station in a single operation. Up to
six AM, FM1 and FM2 stations each may be preset.