CIRCUTOR OPTIM HYB Series - Manual (Page 7)

When unloading and moving the unit, use a forklift with forks long enough to support the entire
length of the base. Otherwise, the forks should be long enough to support at least ¾ of said
depth. The forks must be flat and supported firmly by the base. Raise the cabinet by placing the
forks underneath the profile that supports the unit. ( Figure 2 ).
There might be an offset in the centre of gravity from the centre of the cabinet,
as a result of the uneven distribution of loads inside the unit. The necessary
precautions must be taken to prevent the unit from tipping over during abrupt
operations.
Figure 2: Unloading with a forklift.
1.3.- STORAGE
The following storage recommendations must be followed for the hybrid capacitor banks:
 Avoid placing them on uneven surfaces.
 Do not store them in outdoor areas, humid areas or areas exposed to splashing
water.
 Avoid hot spots (maximum ambient temperature: 40 ºC)
 Avoid salty and corrosive environments.
 Avoid storing the units in areas where a lot of dust is generated or where the risk of
chemical or other types of contamination is present.
 Do not place any weight on top of the unit cabinets.
7 Instruction Manual
OPTIM HYB Series