Crompton Controls M10 - Manual (Page 15)

Emotron AB 01-2550-01r3 Operation 13
7 Operation
Make sure that the enclosed plastic (rubber) insert (if ordered, optional) covers
the monitor terminals before you start programming.
If the normal machine load level is exceeded, the internal relay changes state and
the Power/Alarm LED turns red. The LED is green at "power on" and at nor-
mal load.
7.1 LED
• A constant green LED indicates a parameter type.
• A flashing green LED indicates a value.
Under normal system operation, the eight LEDs are all off (see table 2, page
18). Any illuminated LEDs will be automatically switched off 30 seconds after
the last key press.