Junger Audio b40 - Digital Audio Toolbox - Manual (Page 26)

5. OPERATION
1/2 or 3/4 to switch for the input 1/2 or 3/4 between
5.3
INPUT
SELECTION
AES and SDI
push
5.4
TRANSPARENT
MODE
TRANSPARENT
to establish bit transparent connection
between input and output 1/2 or 3/4 or
1/2 and 3/4 (necessary to pass non-audio
bit streams through without changing)
DELAY means delaying of input signals. The delay can be changed in
steps of 1ms, within a range from 0...160 ms.
Adjustment of DELAY is channel independent. GAIN adjustment is
stored into the presets.
DELAY selection of channel
DELAY adjustment of delay for selected channel
push
push
turn
5.5
DELAY
MASTER to adjust all channels together
with the same value
INPUT GAIN means linear amplification of input signals. The input gain
can be changed in steps of 0.1 dB , within a range from -15...+15 dB.
Adjustment of GAIN is channel independent. GAIN adjustment is
stored into the presets.
GAIN selection of channel
GAIN adjustment of gain for selected channel
MASTER to adjust all channels together
with the same value
push
turn
push
push
5.6
INPUT GAIN
5.7
MATRIX
The matrix is to configure with the INPUT buttons and the OUTPUT
buttons.
1. selection of input channel by pushing related INPUT button
2. selection of requested output channel by pushing related OUTPUT
button.
This procedure is to repeat up to all necessary connection are routed.
The configuration of the matrix is stored into the presets.
page 5-4 operation manual b40, chapter 5 -Operation-