Junger Audio d06 - Digital Audio Leveler - Manual (Page 19)

3. INSTALLATION
operation manual d06, chapter 3 - Installation - page 5 of 10
The digital audio level processor d06 can aknowledge specific device statuses
via parallel GPO (Tally) lines.
Use to :
monitor the d06 status
Connector :
D-SUB 25pin
female panel jack
Pin assignment of the connector :
Pin Signal name Functions
1 Tally 1 normally closed
2 Tally 1 normally opened Defined by d06 config
3 TALLY 2 common
4 Tally 3 normally closed
5 Tally 3 normally opened Defined by d06 config
6 TALLY 4 common
7 Tally 5 normally closed
8 Tally 5 normally opened Defined by d06 config
9 Tally 6 common
10 Tally 7 normally closed
11 Tally 7 normally opened Defined by d06 config
12 TALLY 8 common
13 + 5V 110 Ohm
14 TALLY 1 common
15 Tally 2 normally closed
16 Tally 2 normally opened Defined by d06 config
17 TALLY 3 common
18 Tally 4 normally closed
19 Tally 4 normally opened Defined by d06 config
20 TALLY 5 common
21 Tally 6 normally closed
22 Tally 6 normally opened Defined by d06 config
23 TALLY 7 common
24 Tally 8 normally closed
25 Tally 8 normally opened Defined by d06 config
Screen -5V GND of do6 chassis
Electrical specifications :
Tally output relay :
common / normally closed / normally opened
24V - 1A
125V - 0,5A
P
max
= 62,5VA
3.7.3
GPO (TALLY)